Operation Panel
6-56
TCP/IP Settings (optional network interface card TCP/IP Settings)
This selects the TCP/IP settings.
The options available in the TCP/IP Settings are as follows:
• TCP/IP (Enable/Disable TCP/IP)
• IPv4 Setting (TCP/IP IPv4 settings)
• IPv6 Setting (TCP/IP IPv6 settings)
1 In the Network Settings menu, press U or V to select TCP/IP
Settings.
2 Press [OK]. The TCP/IP Settings menu screen appears.
TCP/IP (Enable/Disable TCP/IP)
This specified whether TCP/IP is used.
The method for setting is the same as for the standard Network settings. For details, refer to TCP/IP (Enable/Disable TCP/
IP) on page 6-40.
IPv4 Setting (TCP/IP IPv4 settings)
This selects the settings for TCP/IP (IPv4). The method for setting is the same as for the standard Network settings. For
details, refer to IPv4 Setting (TCP/IP IPv4 settings) on page 6-41.
IPv6 Setting (TCP/IP IPv6 settings)
This selects the settings for TCP/IP (IPv6). The method for setting is the same as for the standard Network settings. For
details, refer to IPv6 Setting (TCP/IP IPv6 settings) on page 6-44.
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the standard by the IETF for authentication and encryption in
the third network layer (IP layer).
It can be used with both IPv4 and IPv6.
1 In the Basic menu, press U or V to select IPSec.
2 Press [OK]. The IPSec screen appears.
3 Press U or V to select whether IPSec is enabled.
4 Press [OK]. The IPSec setting is set and the Basic menu reappears.
TCP/IP Settings:
a
b
********************-
2
IPv4 Setting
3
IPv6 Setting
[ Exit ]
1
TCP/IP
Note IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP addresses.
IPSec:
a
b
********************-
2
On
1
*Off
To Next Page
Loading...
