6-57
Operation Panel
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used. The default setting is Auto.
1 In the Basic menu, press U or V to select LAN Interface.
2 Press [OK]. The LAN Interface screen appears.
The available LAN Interface are as follows:
Auto
10BASE-Half
10BASE-Full
100BASE-Half
100BASE-Full
1000BASE-T
3 Press U or V to select the desired LAN Interface.
4 Press [OK]. The LAN Interface is set and the Basic menu
reappears.
MACAddressFilter (MAC address filtering setting)
This sets whether or not to enable MAC address filtering.
1 In the Basic menu, press U or V to select MACAddressFilter.
2 Press [OK]. The MACAddressFilter screen appears.
3 Press U or V to select whether MAC address filtering is enabled.
4 Press [OK]. The MAC address filtering setting is set and the Basic
menu reappears.
Note LAN Interface is only displayed when the optional network interface card (IB-50) is installed.
LAN Interface:
a
b
********************-
2
10BASE-Half
3
10BASE-Full
1
*Auto
Note The detailed settings for MAC address filtering are selected using the optional network interface card utility
software.
MACAddressFilter:
a
b
********************-
2
On
1
*Off
To Next Page
Loading...
