5-6
Sending Functions
Duplex Sending
Select the type and binding of original depending on the original.
The table below lists the binding directions for each original type.
Use the procedure below to select the original type and binding direction when sending scanned originals.
1
Press the
Send
key.
2
Place the originals on the document processor.
3
Press the
Function Menu
key. Function Menu appears.
4
Press the
or
key to select [Duplex].
5
Press the
OK
key. Duplex appears.
6
Press the
or
key to select [1-sided] or [2-sided].
If you select [2-sided], press [Detail] (the
Right Select
key), select the binding edge and press the
OK
key, and
then select the original setting orientation on the next
screen.
7
Press the
OK
key.
Completed.
is displayed and the screen returns to the
basic screen for sending.
8
Specify the destination, and press the
Start
key to start
sending.
NOTE:
Press the
Reset
key to reset the settings selected in
Function Menu.
Original Type Binding Binding
1-sided Sheet Original 1-sided — —
2-sided Sheet Original 2-sided Binding Left/Right,
Binding Top
Top Edge Top ,
Top Edge Left
To Next Page
Loading...
