Kyocera ECOSYS M2030dn

8-118
Default Setting (System Menu)
4 Press the OK key. Backgrnd Density appears.
5 Press the  or  key to select [Copy(Auto)] or [Send/
Box(Auto)].
6 Press the OK key. This displays the density selection
screen for the mode selected in step 5. The screen
shown is the one when [Copy(Auto)] is selected.
7 Press the  or  key to select the density from [-3
Lighter] to [+3 Darker].
8 Press the OK key. Completed. is displayed and the
screen returns to the Backgrnd Density menu.
Print Density
Adjust Print Density.
Use the procedure below to adjust the Print Density.
1 In the Sys. Menu/Count. menu, press the  or  key to
select [Adjust/Maint.].
2 Press the OK key. The Adjust/Maint. menu appears.
3 Press the  or  key to select [Print Density].
4 Press the OK key. Print Density appears.
Backgrnd Density: a b
*********************
2 Send/Box(Auto)
[ Exit ]
1 Copy(Auto)
Copy(Auto): a b
3 -1
*********************
5 +1
4 * 0 Normal
Sys. Menu/Count.: a b
: Document Box
; Edit Destination
*********************
[ Exit ]
< Adjust/Maint.
Adjust/Maint.: a b
*********************
2 Send/Box Density
3 Backgrnd Density
[ Exit ]
1 Copy Denst. Adj.
Print Density: a b
2 2
*********************
4 4
3 *3