Kyocera ECOSYS M2030dn

8
8-101
Default Setting (System Menu)
Use the procedure below to set Select Key Set.
1 In the Sys. Menu/Count. menu, press the  or  key to
select [Send].
2 Press the OK key. The Send menu appears.
3 Press the  or  key to select [Select Key Set.].
4 Press the OK key. Select Key Set. appears.
5 Press the  or  key to select [Left] or [Right].
6 Press the OK key. This displays the function selection
screen for the flexible key selected in step 5. The screen
shown is the one when [Left] is selected.
7 Press the  or  key to select the function you want to
register to the flexible key.
8 Press the OK key. Completed. is displayed and the
screen returns to the Send menu.
IMPORTANT: If you try to set the function that is registered
to the other flexible key, you cannot set it and
This function is
already registered. is displayed.
Sys. Menu/Count.: a b
6 Copy
7 Printer
*********************
[ Exit ]
8 Send
Send: a b
*********************
2 DestinationCheck
3 Default Screen
[ Exit ]
1 Select Key Set.
Select Key Set.: a b
*********************
2 Right
[ Exit ]
1 Left
Left: a b
\ Density
*********************
FTP Encrypted TX
*Duplex
This function is
already registered.