Kyocera ECOSYS M2030dn

8
8-157
Default Setting (System Menu)
2 The System/Network menu appears.
3 Press the  or  key to select [Network Setting].
4 Press the OK key. The Network Setting menu appears.
5 Press the  or  key to select [Secure Protocol].
6 Press the OK key. Secure Protocol appears.
7 Press the  or  key to select [IPP Security].
8 Press the OK key. IPP Security appears.
9 Press the  or  key to select [IPP/IPP over SSL] or
[IPPoverSSL only].
10 Press the OK key. Completed. is displayed and the
screen returns to the Secure Protocol menu.
HTTP Security
Specify the protocol to be used for HTTP. The default setting is HTTPS only .
Use the procedure below to make the setting.
1 In the Sys. Menu/Count. menu, press the  or  key to
select [System/Network], and press the
OK key.
System/Network: a b
*********************
2 I/F Block Set.
3 Security Level
[ Exit ]
1 Network Setting
Network Setting: a b
*********************
6 Host Name
7 LAN Interface
[ Exit ]
5 Secure Protocol
Secure Protocol: a b
1 SSL
*********************
3 HTTP Security
[ Exit ]
2 IPP Security
IPP Security: a b
1 IPP/IPP over SSL
*********************
2 *IPPoverSSL only
Sys. Menu/Count.: a b
1 Report
2 Counter
*********************
[ Exit ]
3 System/Network