2A3/4
2-1-5
8. Bypass paper length switch (BYPPLSW) ....Detects the length of paper on the
bypass table.
9. Bypass paper width switch (BYPPWSW) ....Detects the width of paper on the
bypass table.
10. Bypass table extended detection switch ......Detects when the bypass table support
(BYPEDSW) guide is extended to use long paper.
11. Upper lift limit switch (LICSW-U) .................Detects the upper drawer lift reaching
the upper limit.
12. Lower lift limit switch (LICSW-L) ..................Detects the lower drawer lift reaching
the upper limit.
13. Paper feed switch 1 (PFSW1) .....................Controls feed clutch 4.
14. Paper feed switch 2 (PFSW2) .....................Controls feed clutch 1, 2 and 3, and the
upper paper feed clutch.
15. Paper feed switch 3 (PFSW3) .....................Controls the lower paper feed clutch.
16. Paper feed switch 4 (PFSW4) .....................Controls feed clutch 3.
17. Feed switch (FSW) ......................................Controls the secondary paper feed start
timing.
18. Registration switch (RSW) ...........................Controls the secondary paper feed end
timing.
19. Eject switch (ESW) ......................................Detects paper jam in the fixing section.
To Next Page
Loading...
