3-1-30
2A3/4
3-1-3 Installing the memory copy kit
(42 ppm: option/52 ppm: standard)
Memory copy kit installation requires the following parts:
Memory copy kit (P/N 2AC82020)
Contents of the kit
• Memory copy PCB (assembly, P/N 2AC01120)
• Three (3) BVM4 × 6 bronze binding screws (P/N B1304060)
<Procedure>
1. Detach the SRDF connector.
2. Remove the seven screws holding the rear cover and then the cover.
3. Remove the eight screws holding the main PCB cover and then the cover.
M4
Screws
Main PCB cover
Screws
Screws
Figure 3-1-37
To Next Page
Loading...
