Kyocera KM-4230

2A3/4
3-3-45
3-3-5 Drum section
( 1 ) Replacing the drum.
Replace the drum as follows.
<Precautions>
• Avoid direct sunlight and strong light when detaching and refitting the drum.
• Hold the drum at the ends and never touch the drum surface.
• After removing the drum, keep it in the drum case or storage bag to protect the
surface from light.
<Procedure>
1. Open the front cover.
2. Lower the paper conveying section by turning the paper transfer section release
lever as shown in Figure 3-3-52.
∗ While pressing the image formation unit release button, pull the image formation
unit out from the machine.
Paper transfer section
release lever
Image formation unit release button
Image formation unit
*Illustration shows a 42 ppm.
Figure 3-3-52 Drawing the image formation unit