Kyocera KM-4230

2A3/4
3-6-97
Clean with isopropyl alcohol.
Replace if necessary (see page
3-3-3).
Replace if necessary (see page
3-3-3).
See pages 3-6-77 – 79.
Clean with isopropyl alcohol.
See page 3-6-79.
Check the width guide visually
and correct or replace if neces-
sary.
Check the width guide visually
and correct or replace if it is
deformed.
Repair or replace.
(1)
No primary
paper feed.
(2)
No secondary
paper feed.
(3)
Skewed paper
feed.
Check if the surfaces of the
following rollers or pulleys are
dirty with paper powder: for-
warding pulleys, upper/lower
paper feed pulleys, upper/lower
feed rollers, feed rollers 1/2/3/4,
feed pulleys, bypass forwarding
pulley and bypass upper/lower
paper feed pulleys.
Check if the upper or lower pa-
per feed pulley is deformed.
Check if the forwarding pulley is
deformed.
Electrical problem with the fol-
lowing electromagnetic
clutches: upper/lower paper
feed clutches, feed clutches 1/
2/3/4/5 and bypass paper feed
clutch.
Check if the surfaces of the
upper and lower registration
rollers are dirty with paper pow-
der.
Electrical problem with the reg-
istration clutch.
Width guide in a drawer in-
stalled incorrectly.
Deformed width guide in a
drawer.
Check if a pressure spring
along the paper conveying path
is deformed or out of place.
Problem Causes/check procedures Corrective measures
3-6-5 Mechanical problems
• Copier