2A3/4
3-3-80
3-3-10 Feedshift and duplex section
( 1 ) Detaching and refitting the duplex forwarding pulley
Replace the duplex forwarding pulley as follows.
<Procedure>
1. Open the duplex unit.
2. Remove the stop ring and duplex forwarding pulley.
3. Refit all removed parts.
∗ When fitting the duplex forwarding pulley, align the projections of the duplex
forwarding pulley with the slots in the forwarding pulley.
Slots
Forwarding pulley
Stop ring
Projections
Duplex forwarding
pulley
Figure 3-3-94
To Next Page
Loading...
