2A3/4
3-3-79
(10) Adjusting the fixing pressure (reference)
Adjust fixing pressure when paper creases, fixing is defective, or after the fixing
pressure spring is replaced.
<Procedure>
Enter maintenance mode.
Enter "161" using the numeric
keys and press the print key.
Yes
No
Start
End
Press the print key.
Wait for 30 s and remove
the jammed paper manually.
Press the interrupt key.
Exit maintenance mode.
Is the
width of the
black band printed on
the image (indicating the part
which stopped in the
fixing section)
7.0 ± 0.5
mm?
Turn the fixing pressure nuts to
adjust the fixing pressure.
Press the interrupt key.
Clean the heat and
press roller if they are dirty.
Fixing pressure nuts
Figure 3-3-93
7.0±0.5 mm
• Fixing pressure: 210 N
(both machine front
and rear)
Figure 3-3-92
To Next Page
Loading...
