Kyocera KM-4230

2A3/4
3-6-23
Check if the registration clutch
malfunctions.
Electrical problem with the reg-
istration clutch.
Check if the upper and lower
registration rollers contact each
other.
Check if the upper and lower
feed rollers contact each other.
Check if the registration clutch
malfunctions.
Electrical problem with the reg-
istration clutch.
Check if the upper and lower
registration rollers contact each
other.
Check if the upper and lower
feed rollers contact each other.
Check if the fixing unit front
guide is deformed.
Check if the press roller is ex-
tremely dirty or deformed.
Check if the heat roller separa-
tion claws are dirty or de-
formed.
Check if the heat roller and its
separation claws contact each
other.
Check if the eject roller and
eject pulley contact each other.
Check visually and remedy if
necessary.
Check (see page 3-6-81).
Check visually and remedy if
necessary.
Check visually and remedy if
necessary.
Check and remedy if neces-
sary.
Check (see page 3-6-81).
Check visually and remedy if
necessary.
Check visually and remedy if
necessary.
Repair or replace if necessary.
Clean or replace if necessary.
Clean or replace if necessary.
Remedy if the separation claw
springs are out of place.
Remedy.
(10)
A paper jam
in the paper
conveying
section is indi-
cated during
copying (jam
in registration/
transfer
section).
(11)
A paper jam
in the fixing
section is indi-
cated during
copying (jam
in fixing sec-
tion).
(12)
A paper jam
in the eject
section is indi-
cated during
copying (jam
in eject
section).
Problem Causes/check procedures Corrective measures