Kyocera KM-4230

2A3/4
3-3-56
3-3-7 Transfer and separation section
( 1 ) Replacing the charger wires and cleaning pads
Take the following steps when the charger wire is broken or is to be replaced, or when
replacing the cleaning pads.
<Precautions>
• Use only the specified tungsten wire for the charger wire.
• The part of the wire wrapped around the charger spring must not protrude from the
rear of the transfer charger housing.
• The cut end of the charger wire must not protrude from under the charger wire
retainer pin.
• Keep the charger wire taut by stretching the charger spring.
• Clean the charger shield when replacing the charger wire.
<Procedure>
1. Turn the paper transfer section release lever to the right to lower the paper
conveying section.
2. Remove the connector, pin and then the transfer charger assembly.
Connector
Paper transfer section
release lever
Transfer charger assembly
Pin
*Illustration shows a 42 ppm.
Figure 3-3-66 Detaching the transfer charger assembly