Kyocera KM-4230

2A3/4
3-6-100
Problem Causes/check procedures Corrective measures
The surfaces of the DF forward-
ing pulleys, DF original feed
pulley or DF separation pulley
are dirty with paper powder.
Check if the DF original feed
pulley or the DF separation pul-
ley is deformed.
Check if the DF forwarding pul-
leys are deformed.
Electrical problem with the fol-
lowing clutch or solenoid:
• Original feed solenoid
• Original feed clutch
The DF registration pulley and
the DF registration roller do not
contact each other correctly.
Originals outside the specifica-
tions are used.
The surfaces of the DF forward-
ing pulleys, DF original feed
pulley or DF separation pulley
are dirty with paper powder.
The DF original feed pulley and
the DF separation pulley do not
contact each other correctly.
(1)
No primary
original feed.
(2)
No secondary
original feed.
(3)
Originals jam.
Check and clean them with iso-
propyl alcohol if they are dirty.
If so, replace (see pages 3-3-89
and 91).
If so, replace (see page 3-3-
89).
See pages 3-6-88 and 90.
Remedy.
Use only originals conforming
to the specifications.
Check and clean them with iso-
propyl alcohol if they are dirty.
Remedy.
• SRDF