Kyocera KM-4230

2A3/4
3-3-46
3. Remove the two screws holding the main charger assembly and then the assembly.
Screws
Main charger assembly
Figure 3-3-53 Detaching the main charger assembly
4. Loosen the cleaning blade pin. Move the cleaning blade lever in the direction of the
arrow so that the cleaning blade is kept away from the drum and then tighten the
cleaning blade pin.
5. Remove the two screws and open the upper cleaning cover on the left of the drum.
6. Remove the two screws and open the image formation rail in the direction of the
arrow.
Screw
Image formation rail
Cleaning blade lever
Cleaning blade pin
Upper cleaning cover
Screw
Screw
Screw
Figure 3-3-54