Kyocera KM-4230

2A3/4
3-3-47
7. Detach the 1-pin and 4-pin connectors.
8. While raising the toner sub-hopper slightly, slide the hopper toward the front of the
image formation unit and turn the image formation unit to the right.
Toner sub-hopper
1-pin connector
4-pin connector
Figure 3-3-55
9. Move the developing unit to the right of the image formation unit and remove it from
the unit.
10. Remove one screw each from the drum front and rear retainers and then the drum
from the image formation unit.
Drum
Screw
Screw
Developing unit
Image formation
unit
Drum rear retainer
Drum front retainer
Figure 3-3-56 Detaching the developing unit and the drum