3-2-32
2A3/4
Description
Maintenance
item No.
U092 Adjusting the scanner automatically
Description
Makes auto scanner adjustments in the order below using the specified
original.
• Adjusting the scanner center line (U067)
• Adjusting the scanner magnification in the main scanning direction
(U065)
• Adjusting the scanner leading edge registration (U066)
• Adjusting scanner magnification in the auxiliary direction (U065)
When this maintenance item is performed, the settings in U065, U066 and
U067 are also changed.
Purpose
Used to make respective auto adjustments for the scanner.
Method
1 Place the specified original (P/N: 2AC68240) on the contact glass.
2 Press the print key. The screen for executing is displayed.
3 Press the print key. Auto adjustment starts. When adjustment is
complete, each adjusted value is displayed.
If a problem occurs during auto adjustment,
an error code is displayed
and operation stops.
Should this happen, determine the details of the
problem and either repeat the procedure from the beginning, or adjust
the remaining items manually by running the corresponding
maintenance items.
Completion
Press the stop/clear key after auto adjustment is complete. The screen for
selecting a maintenance item is displayed.
If the stop/clear key is pressed during auto adjustment, adjustment stops
and no settings are changed.
Display
SCAN CENTER ADJ
MAIN SCAN ADJ
SCAN TIMING ADJ
SUB SCAN ADJ
Description
Scanner center line
Scanner magnification in the main
scanning direction
Scanner leading registration
Scanner magnification in the
auxiliary direction
2AD-1
To Next Page
Loading...
