3-2-69
2A3/4
Maintenance
item No.
Description
Start
Press the print key. The screen for selecting an item is displayed.
Setting the amount of slack in the paper
1 Select PUNCH TIMING on the screen for selecting an item.
2 Change the setting using the Up/Down keys.
I f the position of punch holes varies, increase the setting to make the
amount of slack larger.
If paper jams or is Z-folded frequently, decrease the setting to make
the amount of slack smaller.
Changing the value by 1 changes the amount of slack by 1.25 mm.
3 Press the print key. The value is set.
4 To return to the screen for selecting an item, press the stop/clear key.
Setting the punch limit or displaying the punch-hole scrap count
1 Select PUNCH LIMIT on the screen for selecting an item.
2 Select the item to be set.
3 Change the setting using the numeric keys or the Up/Down keys.
To clear the punch-hole scrap count, press the all clear/reset key.
PUNCH LIMIT can be changed in increments of 1000 times.
When the punch-hole scrap count reaches the punch limit, “Check
punch waste tank.” is displayed on the touch panel.
4 Press the print key. The value is set.
5 To return to the screen for selecting an item, press the stop/clear key.
Description
Punch timing
Setting range
–15 to +15
Initial setting
0
Description
Amount of slack in the paper
Setting range
–15 to +15
Initial setting
0
Display
PUNCH LIMIT
PUNCH CNT
Description
Punch limit (maximum number of
punching times)
Punch-hole scrap count (current
number of punching times)
Setting range
0 to 999000
0 to 999999
Initial setting
75000
—
Display
PUNCH TIMING
PUNCH LIMIT
SADDLE ADJUST
Description
Adjustment of the amount of slack in
the paper in punch mode
Punch limit/punch-hole scrap count
Booklet stapling position adjustment
U248
To Next Page
Loading...
