2A3/4
3-3-17
( 5 ) Adjusting the position of the rack adjuster
Perform the following adjustment if there is a regular error between the centers of the
original and the copy image on paper fed from the drawer.
<Procedure>
Yes
No
Make a test copy at 100%.
Start
End
Is the center of
the image aligned with that
of the original?
Loosen the three screws holding the
rack adjuster and change the position
of the adjuster so that the centers of
the original and the copy image are
aligned.
• For example 1, move it toward the
machine front ( ).
• For example 2, move it toward the
machine rear ( ).
Screws
Rack adjuster
Figure 3-3-23 Adjusting the position of the rack adjuster
Original Copy
example 1
Copy
example 2
Figure 3-3-22
To Next Page
Loading...
