Kyocera KM-4230

2A3/4
3-3-43
3. Remove the screw holding the grid tension plate and then the plate and main
charger grid.
4. Remove the main charger front and rear lids.
5. Remove the charger spring from the charger wire retainer pin and charger terminal,
and then the charger wire.
Charger wire
Charger wire
retainer pin
Main charger rear lid
Main charger
front lid
Charger terminal
Charger spring
Main charger grid
Grid tension
plate
Figure 3-3-50 Detaching the charger wire