Kyocera KM-4230

2A3/4
3-3-82
4. Remove the four screws and the duplex unit from the rails.
5. Remove the two screws holding the duplex cover and then the cover.
6. Detach the 6-pin connector of the side registration section and the 3-pin connector
of the side registration home position switch, and unlock the edging.
7. Remove the paper tapping guide by gently bending it and taking out of the hole in
the machine rear first.
8. Remove the four screws holding the side registration section and slide off the
section toward the machine right.
9. Remove the two screws holding the duplex paper conveying upper cover and then
the cover.
3-pin connector
Duplex paper
conveying upper
cover
Paper tapping guide
Side registration
section
Screw
Screws
Screw
Screws
Screws
Duplex cover
6-pin
connector
Figure 3-3-96 Detaching the duplex cover and side registration section