2A3/4
1-3-38
Charger wire cleaning
The charger wires are cleaned by the transfer charger cleaning pad and separation
charger cleaning pad traveling along each wire. The pads are placed on a slider which
moves back and forth along the charger cleaning spiral as the spiral is turned by the
charger cleaning motor (CCM).
The two shield cleaning sponges travel along the transfer charger shield, cleaning the
inside of the shield.
6
7
3
1
$
8
5
#
2
4
9
@
0
!
Figure 1-3-35 Transfer charger assembly
1 Transfer charger front housing 8 Tungsten wire for separation
2 Transfer charger rear housing 9 Transfer charger cleaning pad
3 Transfer charger front lid 0 Separation charger cleaning pad
4 Transfer charger rear lid ! Shield cleaning sponges
5 Transfer charger shield @ Charger cleaning pad slider
6 Separation guide # Charger cleaning spiral
7 Tungsten wire for transfer $ Charger cleaning motor (CCM)
To Next Page
Loading...
