Kyocera KM-8030

2FB/2FC-2.0
1-4-75
U989
HDD Scandisk
Description
Restores data in the hard disk by scanning the disk.
Purpose
If power is turned off while accessing to the hard disk is performed, the control information in the hard disk
drive may be damaged. Use this mode to restore the data.
Method
1. Press the start key. The screen for executing is displayed.
2. Press EXECUTE on the touch panel. It is displayed in reverse.
3. Press the start key. When scanning of the disk is complete, the execution result is displayed.
4. Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Completion
To exit this maintenance item without executing scandisk, press the stop/clear key.
The screen for selecting a maintenance item No. is displayed.
U990
Checking/clearing the time for the exposure lamp to light
Description
Displays, clears or changes the accumulated time for the exposure lamp to light.
Purpose
To check duration of use of the exposure lamp. Also to clear the accumulated time for the lamp after replace-
ment.
Method
Press the start key. The screen for selecting an item is displayed.
The accumulated time of illumination for the exposure lamp is displayed in minutes.
Clearing
1. Select the item to be cleared.
2. Press the reset key.
3. Press the start key. The accumulated time is cleared, and the screen for selecting a maintenance item
No. is displayed.
Setting
1. Select the item to be cleared.
2. Enter a seven-digit accumulated time using the numeric keys.
3. Press the start key. The time is set, and the screen for selecting a maintenance item No. is displayed.
Completion
To exit this maintenance item without changing the accumulated time, press the stop/clear key.
The screen for selecting a maintenance item No. is displayed.
U991
Checking the scanner operation count
Description
Displays the scanner operation count.
Purpose
To check the status of use of the scanner.
Method
Press the start key. The screen for selecting an item is displayed.
Completion
Press the stop/clear key. The screen for selecting a maintenance No. item is displayed.
Maintenance
item No.
Description
Display Description
CCD Accumulated time for the exposure lamp
CIS Accumulated time for CIS
Display Description
COPY SCAN COUNT Counts of scanner operation
NT SCAN COUNT Counts of network scanner operation