Kyocera KM-8030

2FB/2FC-3
1-6-54
Is the scanner
leading edge registration
correct?
Yes
No
Start
Enter maintenance mode.
Enter 066 using the numeric keys.
Press the start key.
Press the interrupt key.
Place an original and press
the start key to make a test copy.
For copy example 1, increase
the value using the cursor up key.
For copy example 2, decrease
the value using the cursor down key.
Press the start key.
The new setting
is stored.
Press the stop/clear key.
Exit maintenance mode.
End
Setting range (initial setting)
Leading edge registration:
-32 to +32 (10)
Leading edge registration
(second face): -20 to +20 (0)
Changing the value by 1 moves
the center line by 0.17 mm
Touch panel display
ADJUST DATA:
Leading edge registration
ADJUST DATA2:
Leading edge registration (second face)
Select ADJUST DATA
or ADJUST DATA2
on the touch panel.
(10) Adjusting the scanner leading edge registration
Perform the following adjustment if there is regular error between the leading edges of the copy image and original.
<Caution>
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
<Procedure>
Figure 1-6-102
U404
(P. 1-6-95)
U066
Front (CCD adjustment)
Back (CIS adjustment)
U071
(P. 1-6-93)
U404
(P. 1-6-95)
U071
(P. 1-6-93)
U403
(P. 1-6-55)
Original Copy
example 1
Copy
example 2
Scanner leading edge registration