Kyocera KM-8030

2FB/2FC-4
1-6-60
1-6-6 Developing section
(1) Detaching and refitting the developing unit
Procedure
1. Open front cover and then remove the toner
container.
2. Remove the inner cover (see page 1-6-59).
3. Remove two screws and pull out the image
formation unit.
4. Remove the connector and release the lock
stay as shown in the figure.
Figure 1-6-111
5. Remove the developing unit from the image
formation unit.
Figure 1-6-112
Lock stay
Release position
Lock position
Lock stay
Developing unit
Connector
Developing unit