Kyocera KM-8030

2FB/2FC-4
1-6-29
End
Start
Enter maintenance mode.
Enter 051 using the numeric keys.
Yes
Yes
No
No
Press the start key.
*Postcard setting is effective for
only Japanese specification.
Press the interrupt key.
Press the start key
to make a test copy.
Press the stop/clear key.
Exit maintenance mode.
Decrease the value using the cursor down key.
Setting range: -120 to +120
Changing the value by 1 changes
the amount of slack by 0.6 mm.
Initial setting
Plain: 3/Thick: 0
The greater the value,
the larger the amount of slack;
the smaller the value, the smaller
the amount of slack.
The new setting is stored.
Select paper type to be adjusted
on the touch panel.
Plain/Thick/Postcard*
Select the item to be adjusted
on the touch panel.
Thick
BYPASS DATA: Amount of registration slack for MP feed
LOW SPEED DATA: Amount of registration slack for
transportating A3 size paper
HIGH SPEED DATA: Amount of registration slack for
transportating paper smaller than A4 size
Plain
Touch panel display
BYPASS DATA: Amount of registration slack for MP feed
HIGH DUPLEX DATA: Amount of registration slack for transportating
paper smaller than A4 size in duplex mode
LOW DUPLEX DATA: Amount of registration slack for
transportating A3 size paper in duplex mode
LOW SPEED DATA: Amount of registration slack for
transportating A3 size paper
HIGH SPEED DATA: Amount of registration slack for
transportating paper smaller than A4 size
CASSETTE1 DATA: Amount of registration slack for
cassette 1 feed
CASSETTE1 DATA: Amount of registration slack for
cassette 1 feed
Is the leading
edge of the image missing
or varying randomly (copy
example 1)?
Is the copy
paper Z-folded (copy
example 2)?
Increase the value using the cursor up key.
Press the start key.
(8-5) Adjusting the amount of slack in the paper
Make the following adjustment if the leading edge of the copy image is missing or varies randomly, or if the copy paper is
Z-folded.
<Procedure>
Figure 1-6-55
Original Copy
example 1
Copy
example 2