Kyocera KM-8030

2FB/2FC-3
1-6-55
Change the setting.
Increasing the value using the cursor
up key makes the margin wider.
Decreasing the value using
the cursor down key makes the
margin narrower.
Yes
No
Start
Enter maintenance mode.
Enter 403 using the numeric keys.
Press the start key.
Press the start key
to make a test copy.
Press the start key.
The new setting
is stored.
Setting range (initial setting)
Scanner left margin: 0.0 to +10.0 (+3.0)
Scanner leading edge margin: 0.0 to +10.0 (+3.0)
Scanner right margin: 0.0 to +10.0 (+3.0)
Scanner trailing edge margin: 0.0 to +10.0 (+3.5)
Changing the value by one moves
the margin by 0.1 mm for all.
Select the item
to be adjusted on the touch panel.
Are the margins correct?
Press the interrupt key.
Touch panel display
A MARGIN: Scanner left margin
B MARGIN: Scanner leading edge margin
C MARGIN: Scanner right margin
D MARGIN: Scanner trailing edge margin
Yes
No
Press the stop/clear key.
Exit maintenance mode.
End
Proceed to another mode?
(11) Adjusting the margins for scanning an original on the contact glass
Perform the following adjustment if the margins are not correct.
<Caution>
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
<Procedure>
Figure 1-6-103
U404
(P. 1-6-95)
U403
Scanner leading edge margin (3 2.5 mm)
+
-
+
-
Scanner
left margin
(2
+2.0
mm)
Scanner
right margin
(2
+2.0
mm)
Ejection direction
(reference)
Scanner trailing edge margin
(3 2.5 mm)
-1.5
-1.5