2FB/2FC
1-5-3
Section Jam code Description Conditions
System 04 Cover open Cover is open during copying.
05 Memory read ready time-
out
Secondary paper feed does not start even if 30 s elapse after
the registration switch (RSW) is turned on and primary paper
feed is complete.
06 Main charger error An error signal is generated continuously more than 400 ms
when the main charger is turned on during printing.
Paper feed
section
10 No paper feed from cas-
sette 1
Feed switch 2 (FSW2) does not turn on within 480 ms of paper
feed motor 1 (PFM1) turning on.
11 No paper feed from cas-
sette 2
Timing switch 1 (TIMSW1) does not turn on within 200 ms of
the paper feed motor 2 (PFM2) turning on.
12 No paper feed from cas-
sette 3
Timing switch 2 (TIMSW2) does not turn on within specified
time <330 ms (240 ms) for 80 cpm/430 ms (240 ms) for 60
cpm> of paper feed motor 3 (PFM3) turning on.
* Description in ( ) is written for the specified time of less then
A4/11" x 8
1/2" size.
13 No paper feed from cas-
sette 4
Timing switch 3 (TIMSW3) does not turn on within specified
time <330 ms (240 ms) for 80 cpm/430 ms (240 ms) for 60
cpm> of paper feed motor 4 (PFM4) turning on.
* Description in ( ) is written for the specified time of less then
A4/11" x 8
1/2" size.
14 No paper feed from side
feeder
Side feeder feed switch (SFFSW) does not turn on within 2000
ms of the side feeder paper feed clutch (SFPFCL) turning on;
the clutch is then successively held off for 50 ms and turned
back on twice, but the switch again fails to turn on within 848
ms.
15 No paper feed from MP
tray
Feed switch 1 (FSW1) does not turn on within specified time
(500 ms for 80 cpm/643 ms for 60 cpm) of the MP feed motor
(MPFDM) turning on.
19 Misfeed in copier vertical
paper conveying section 2
Feed switch 4 (FSW4) does not turn on within specified time
<330 ms (240 ms) for 80 cpm/430 ms (240 ms) for 60 cpm> of
timing switch 2 (TIMSW2) turning on.
Feed switch 5 (FSW5) does not turn on within specified time
<330 ms (240 ms) for 80 cpm/430 ms (240 ms) for 60 cpm> of
timing switch 3 (TIMSW3) turning on.
Feed switch 4 (FSW4) does not turn on within specified time
<500 ms (400 ms) for 80 cpm/650 ms (400 ms) for 60 cpm> of
feed switch 5 (FSW5) turning on.
* Description in ( ) is written for the specified time of less then
A4/11" x 8
1/2" size.
20 Misfeed in copier vertical
paper conveying section 3
Feed switch 3 (FSW3) does not turn on within specified time
<500 ms (400 ms) for 80 cpm/650 ms (400 ms) for 60 cpm> of
feed switch 4 (FSW4) turning on.
* Description in ( ) is written for the specified time of less then
A4/11" x 8
1/2" size.
To Next Page
Loading...
