Kyocera KM-8030 - Page 181

2FB/2FC-4
1-5-22
(42)
An original jams in
the optional DP is
indicated during
copying (jam in the
original switchback
section 1).
Jam code 75
Defective DP registration
switch.
Run maintenance item U244 and turn the DP registration switch
on and off manually. Replace the DP registration switch if indica-
tion of the corresponding switch on the touch panel is not dis-
played in reverse.
Defective DP timing switch
1.
Run maintenance item U244 and turn DP timing switch 1 on and
off manually. Replace DP timing switch 1 if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
(43)
An original jams in
the optional DP is
indicated during
copying (jam in the
original switchback
section 2).
Jam code 76
Defective DP timing switch
2.
Run maintenance item U244 and turn DP timing switch 2 on and
off manually. Replace DP timing switch 2 if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
(44)
A paper jam in the
optional document
finisher is indicated
during copying
(paper jam during
paper insertion to the
finisher).
Jam code 81
The paper entry roller is
dirty with paper powder.
Check and, if it is dirty, clean it.
The paper entry roller is
deformed or worn.
Check and, if it is deformed or worn, fix or replace it.
Defective paper entry sen-
sor.
Run maintenance item U241 and turn the paper entry sensor on
and off manually. Replace the paper entry sensor if indication of
the corresponding sensor on the touch panel is not displayed in
reverse.
(45)
A paper jam in the
optional document
finisher is indicated
during copying
(paper jam during
paper insertion to the
finisher and paper
ejection to the sub
tray).
Jam code 82
The sub feed roller is dirty
with paper powder.
Check and, if it is dirty, clean it.
The sub feed roller is
deformed or worn.
Check and, if it is deformed or worn, fix or replace it.
Defective paper entry sen-
sor.
Run maintenance item U241 and turn the paper entry sensor on
and off manually. Replace the paper entry sensor if indication of
the corresponding sensor on the touch panel is not displayed in
reverse.
Defective sub tray paper
ejection sensor.
Run maintenance item U241 and turn the sub tray paper ejection
sensor on and off manually. Replace the sub tray paper ejection
sensor if indication of the corresponding sensor on the touch
panel is not displayed in reverse.
(46)
A paper jam in the
optional document
finisher is indicated
during copying
(paper jam at the sid-
ing drum).
Jam code 83
The siding drum is dirty with
paper powder.
Check and, if it is dirty, clean it.
The siding drum is
deformed or worn.
Check and, if it is deformed or worn, fix or replace it.
Defective sub tray paper
ejection sensor.
Run maintenance item U241 and turn the sub tray paper ejection
sensor on and off manually. Replace the sub tray paper ejection
sensor if indication of the corresponding sensor on the touch
panel is not displayed in reverse.
Problem
Causes/check procedures Corrective measures