2FB/2FC
1-5-25
Partial operation control
If any of the following calls for service is detected, partial operation control will be activated. After taking measures against
the cause of trouble, run maintenance item U906 to reset partial operation control.
*Optional.
Code Contents
C0250 Network scanner board* communication problem
C0410 DP communication problem
C0420 Side feeder* communication error
C0640 Hard disk problem
C1010 Lift motor 1 error
C1020 Lift motor 2 error
C1030 Lift motor 3 error
C1040 Lift motor 4 error
C1140 Side feeder lift motor going up error (optional side feeder)
C1150 Side feeder lift motor going down error (optional side feeder)
C1200 Duplex side registration motor error
C2640 Side feeder drive motor error
C3210 Exposure lamp problem
C3310 Optical system (AGC) problem (DP)
C8010 Document finisher* paper conveying motor problem
C8020 Document finisher* punch motor problem
C8030 Document finisher* upper paper conveying belt problem
C8040 Document finisher* lower paper conveying belt problem
C8140 Document finisher* main tray problem
C8150 Document finisher* multi job tray problem
C8170 Document finisher* front upper side registration guide problem
C8180 Document finisher* rear upper side registration guide problem
C8190 Document finisher* lower side registration guide problem
C8210 Document finisher* front stapler problem
C8220 Document finisher* front clincher problem
C8230 Document finisher* rear stapler problem
C8240 Document finisher* rear clincher problem
C8300 Document finisher* centerfold unit communication problem
C8310 Document finisher* centerfold unit side registration guide problem
C8320 Document finisher* centerfold unit centering plate problem
C8330 Document finisher* centerfold blade problem
C9040 DP lift motor going up error
C9050 DP lift motor going down error
C9060 DP EEPROM error
C9070 Communication problem between DP and SHD
C9080 Communication problem between DP and CIS
To Next Page
Loading...
