Kyocera KM-8030

2FB/2FC-2.0
2-4-8
Section
Maintenance
part/location
Method Maintenance cycle Points and cautions Page
Optical
section
Slit glass Clean Every service Clean with a dry cloth (do not
clean with a wet cloth nor
alcohol).
Contact glass Clean Every service Clean with alcohol and then
a dry cloth.
Mirror 1 Clean Every service Clean with alcohol and then
a dry cloth.
Mirror 2 Clean Every service Clean with alcohol and then
a dry cloth.
Scanner lens Clean Every service Clean with a dry cloth.
Reflector Clean Every service Clean with alcohol.
Exposure lamp Check or
replace
Every service Replace if an image prob-
lem occurs.
Run maintenance item U990
to check the accumulated
time and replace the lamp if
the time exceeds more than
60,000 min.
P.1-6-34
P.1-4-75
Optical rail Grease Every service Check noise and shifting and
then apply scanner rail
grease PG-671.
Original size
detection sensor
Clean Every service Clean the sensor emitter and
sensor receiver with alcohol
or a dry cloth only if there is a
problem.
Section
Maintenance
part/location
Method
Maintenance cycle Points and cautions Page
Drum section Drum Clean
Check and
replace
Every service Clean with a dry cloth.
Replace if the scratches on
the drum.
P.1-6-56
Potential sensor Clean Every service Air blow (do not vacuum).
Drum heater electrode Clean
Check and
replace
Every service Clean with a dry cloth.
Replace if the resistance
between the disk and elec-
trode is 10
Ω or more.
P.1-6-59