Kyocera KM-8030 - Page 448

2FB/2FC-2.0
2-4-10
Section
Maintenance
part/location
Method
Maintenance cycle Points and cautions Page
Fuser
section
Lower cleaning roller Replace Every service
P.1 -6-71
Press roller Replace Every service P.1 -6-72
Press roller separation
claws
Clean Every service
Cleaning felt Replace Every service
P.1 -6-73
Fuser thermistor Check and
replace
Every service Replace if the film is
scraped.
P.1 -6-75
Fuser heater M/S/L Check and
replace
Every service Replace if it is blackened. P.1 -6-76
Heat roller Replace Every service P.1 -6-79
Heat roller separation
claws
Replace Every service P.1 -6-80
Heat roller gear Check and
replace
Every service P.1 -6-79
Fuser joint gear Replace and
grease
Every service When replacing with the
new gear, after cleaning the
shaft, apply grease EM-50L
to the gear inside.
P.1 -6-79
Fuser eject upper
roller
Replace Every service Replace after feeding
1000,000 sheets.
P.1 -6-81
Gear 88 fuser Grease Every service Apply grease EM-50LS.
Guides Clean Every service Clean with alcohol or a dry cloth.
Section
Maintenance
part/location
Method Maintenance cycle Points and cautions Page
Duplex
section
Rollers Clean Every service Clean with alcohol or a dry cloth.
Guides Clean Every service Clean with alcohol or a dry cloth.
Duplex feedshift sole-
noid
Check and
replace
Every service
Duplex switchback
solenoid
Check and
replace
Every service Run maintenance item U922
to check and clear the count.
P.1 -4-72
Section
Maintenance
part/location
Method Maintenance cycle Points and cautions Page
Feedshift
section
Feedshift solenoid Check and
replace
Every service
Run maintenance item U922
to check and clear the count.
P.1 -4-72
Rollers Clean Every service Clean with alcohol or a dry cloth.
Guides Clean Every service Clean with alcohol or a dry cloth.