2FB/2FC-2.0
1-3-34
3. Insert the board support into the elongate
hole. Secure the board support by rotating
either clockwise/counterclockwise for 90
degrees. Be careful not to pinch the power
cable.
4. Connect the security board to the YC27 con-
nector of the main PWB. Secure it with the
board support.
5. Return the right sequence cover and rear
middle cover to their original positions.
Figure 1-3-69
6. Plug the machine into a power outlet, and
turn on its main power switch.
7. Confirm that the hard disk icon is displayed
on (the right upper corner of) the touch
panel.
Figure 1-3-70
Board support
Power cable
Security
board
A4
Paper Size Set
Merge copy
Eras e
Margin/
Imag.Shift
Program
Exposure
Auto
Staple
/Punch
Staple
Left Top
None
100%
Mode
Exposure
Mode
Hard disk icon
To Next Page
Loading...
