Kyocera TASKalfa 221 - Margin Width Default Value; Border Erase Width Default Value

System Menu
3-10
5
Press the Enter key.
6
Press the Reset key. The message display returns to the copier basic screen.
Margin Width Default Value
Set the default value of the margin width.
1
Display the Copy Default screen. (See How to Display the Copy Default Screen on page 3-2.)
2
Press the S key or the T key to select Margin
Width.
3
Press the Enter key.
4
Press the S key or the T key to set the default value
of margin width. You can set the value to 1/8" to 3/4" in
1/8" increments [1 mm to 18 mm in 1 mm increments].
5
Press the Enter key.
6
Press the Reset key. The message display returns to the copier basic screen.
Border Erase Width Default Value
Set the default value of the border erase width.
1
Display the Copy Default screen. (See How to Display the Copy Default Screen on page 3-2.)
2
Press the S key or the T key to select
BorderEraseWidth [Border Er. width].
3
Press the Enter key.
4
Press the S key or the T key to set the default value
of border erase width. You can set the value to 1/8" to
3/4" in 1/8" increments [1 mm to 18 mm in 1 mm
increments].
5
Press the Enter key.
6
Press the Reset key. The message display returns to the copier basic screen.
Margin Width
Auto Rotation
Offset Off:
1/4":
Copy Default:
On:
Margin Width :
1/8"1/4" 3/4"
BorderEraseWidth
Margin Width
Auto Rotation
1/4":
Copy Default:
On:
1/4":
Border Erase Width:
1/8"1/4" 3/4"