Kyocera TASKalfa 221

System Menu
3-19
6
Press the Reset key. The message display returns to the copier basic screen.
Auto Low Power Time
Set the time that elapses before the low power mode is automatically activated.
Time that can be set:
Inch Specification — 1 to 240 minutes (in 1 minute increments)
Metric Specification — 1 to 120 minutes (in 1 minute increments)
1
Display the Machine default screen. (See How to Display the Machine Default Screen on
page 3-12.)
2
Press the S key or the T key to select Low power
time.
3
Press the Enter key.
4
Press the < key or the > key to select the desired time
from 1 to 240 minutes [1 to 120 minutes].
5
Press the Enter key.
6
Press the Reset key. The message display returns to the copier basic screen.
Copy Output Destination
Set the paper output destination with priority for copying.
Note This item is displayed only if the optional finisher or job separator is installed.
1
Display the Machine default screen. (See How to Display the Machine Default Screen on
page 3-12.)
2
Press the S key or the T key to select Copy Otput
Destn.
3
Press the Enter key.
4
Press the S key or the T key to select the desired
output destination.
Machine Default :
Orig. Orient. Top Edge:
:
Low Power Time :
Sleep Mode Time 1 Min.
1Min.
Low Power Mode Time :
1-240Min.1 Min.
Setting item Output destination
Top tray Output tray of main body
Finisher Tray Output Optional finisher
Job separator Optional job separator
Machine Default :
Copy Otput Destn Top Tray:
:
Low Power Time :
Sleep Mode Time 1 Min.
1Min.
Copy Output Destination :
Top Tray
Finisher
*