What does 'Check the document processor' mean on my Kyocera All in One Printer?
If your Kyocera All in One Printer displays 'Check the document processor', close the document processor. If the top cover of the document processor is open, close it.
How to fix moire patterns on copies from Kyocera All in One Printer?
If your Kyocera All in One Printer's copies have a moire pattern, and the original is a printed photograph, set the image quality to [Print Photo].
Why does my Kyocera TASKalfa 250ci All in One Printer often jam?
Frequent paper jams in your Kyocera All in One Printer could be due to: * Incorrectly loaded paper. Load the paper correctly. * Unsupported or poor condition paper. Remove the paper, turn it over, and reload it. * Curled, folded, or wrinkled paper. Replace the paper with new paper. * Loose scraps or jammed paper in the machine. Remove any jammed paper.
What to do if Kyocera TASKalfa 250ci All in One Printer says 'Check the document processor'?
If your Kyocera All in One Printer displays the message 'Check the document processor': * The document processor might be open. Close it. * The top cover of the document processor might be open. Close it.
Why doesn't the Start key work on my Kyocera All in One Printer?
If pressing the Start key on your Kyocera All in One Printer doesn't produce copies, check for a message on the touch panel and respond accordingly. Also, if the machine is in Sleep mode, press the Power key to wake it up. It should be ready to copy within 45 seconds.
What to do if Kyocera TASKalfa 250ci gives Job Accounting restriction exceeded?
The number of pages used has exceeded the limit set by Job Accounting, and no further operation is possible. Press [End] to cancel the job. Try the job again after resetting the limit for paper use.
Why Kyocera TASKalfa 250ci All in One Printer cannot perform memory forwarding using a sub address?
The reasons why memory forwarding using a sub address may fail: * The recipient fax machine must have a sub address transmission feature for this function to work. * The entered sub address must match the one registered in the recipient fax machine. If your entry is correct, check with the recipient. Note: This machine does not use a sub address password for reception.
What to do if Kyocera All in One Printer says 'Check the cover'?
If your Kyocera All in One Printer displays the message 'Check the cover,' close the cover indicated on the touch panel.
What to do if the finisher tray is full on my Kyocera All in One Printer?
If your Kyocera All in One Printer displays 'Finisher tray is full of paper', remove paper from the document finisher tray. If printing can be restarted, the touch panel display will prompt you to press [Continue]. Then press [Continue].
What to do if my Kyocera All in One Printer has a paper jam?
If a paper jam occurs, the Kyocera All in One Printer will stop, and the location of the jam will be indicated on the touch panel. Leave the machine on and follow the instructions to remove the jammed paper.
General| Functions | Print, Copy, Scan, Fax |
|---|---|
| Copy Resolution | 600 x 600 dpi |
| Duplex Printing | Standard |
| Type | Color Multifunctional |
| Print Speed | 25 ppm |
| Print Resolution | 600 x 600 dpi, Multi-bit technology for print quality of 9, 600 x 600 dpi equivalent |
| Copy Speed | 25 copies per minute (A4) |
| Scan Resolution | 600 dpi |
| Fax Resolution | 200 x 200 dpi, 300 x 300 dpi |
| Memory | 1 GB |
| Hard Disk Drive | 80 GB |
| Network Connectivity | Ethernet, USB |
| Scan Features | Scan to e-mail, Scan to FTP, Scan to SMB, Scan to USB Host, TWAIN scan |
Explanation of symbols used for safety warnings and prohibited/required actions.
Instructions for loading paper into the cassettes and multi-purpose tray.
Procedures for placing originals on the platen or in the document processor.
Steps for turning the machine's main power on and off.
Instructions for logging in and out of the machine when user login administration is enabled.
Step-by-step guide for performing basic copying operations.
Overview of sending scanned images via E-mail, PC, or Document Box.
Explains the functions and basic operations of the Document Box feature.
Procedure to specify the size of originals for scanning.
How to select the paper source for copying.
Enabling additional copies after a job is completed, with optional password protection.
Selecting the original size for scanning.
Selecting the size of the image to be sent.
Selecting the file format for sending scanned images.
Restricting access to PDF files by assigning passwords for display, print, or edit.
Creating, editing, and managing custom boxes for storing documents.
Information on Private Print, Stored Job, Quick Copy, and Proof and Hold Job Boxes.
Checking the status of jobs being processed or waiting to be printed.
Reviewing the history of completed jobs.
Pausing and resuming all printing jobs in printing/waiting status.
Suspending current job to prioritize a waiting job.
Checking toner, paper, and staple levels on the touch panel.
Configuring or checking the status of installed devices and lines.
Configuration of common settings like language, sound, and units.
Settings related to copying functions such as paper selection and zoom.
Adjusting print quality and performing machine maintenance procedures.
Resetting the machine's hard disk to its default mode.
Configuring network settings including host name and TCP/IP protocols.
Procedures for cleaning the machine's exterior and internal components.
Instructions for replacing toner containers and the waste toner box.
General guidelines for diagnosing and solving common machine problems.
How to respond to various alphanumeric error messages displayed on the touch panel.
Step-by-step instructions for clearing paper jams from different locations.
Specifies how user access is administered, including authentication methods.
Manages copy/print counts by assigning IDs to accounts.
Detailed technical specifications of the machine and its components.
To Next Page
