Kyocera TASKalfa 5551ci - CF Side Registration Motor 1 Error

2L6/2N6/2N5/2N4-3
1-4-184
8350 CF side registration motor 1
error
(4000-sheet finisher)
When initial operation, CF
side registration sensor 1
does not turn on within 1 s.
CF side registration
motor 1
1. Execute U240 Booklet - Width Test to
check the finisher operation (see page
1-3-134).
2. Manipulate the side registration lower
guide back and forth to check it can
smoothly operable.
3. Check that the drive from the motor
reaches the side registration lower
guide.
4. Confirm that the wiring connector is
firmly connected and, if necessary,
connect the connector all the way in.
CF side registration motor 1 and CF
main PWB (YC10)
5. If the wiring is disconnected, shorted or
grounded, replace the wiring.
6. Replace the CF side registration motor
1.
CF side registration
sensor 1
1. Execute U241 Booklet - Width Down HP
to check the finisher switch (see page 1-
3-136).
2. Check that the sensor and its mounting
bracket are correctly positioned.
3. Confirm that the wiring connector is
firmly connected and, if necessary,
connect the connector all the way in.
CF side registration sensor 1 and CF
main PWB (YC20)
4. Replace the CF side registration sensor
1.
CF main PWB Replace the CF main PWB
Code Contents Related parts
Check procedures/
corrective measures