Kyocera TASKalfa 5551ci - Hard Disk Encryption Key Error; Hard Disk Overwriting Erasure Error; Image Processing Error; FAX Control PWB Flash Program Area Checksum Error

2L6/2N6/2N5/2N4
1-4-67
0660 Hard disk encryption key
error
EEPROM
1. Execute U004 if this occurs after the
EEPROM has been changed.
HDD
1. If an abnormal noise is heard from the
HDD, replace the HDD.
2. Check the SATA wiring between the
HDD and the main circuit PWB for loose
connection, disconnection and
damages, and that it is connected into
the correct terminal.
Main PWB: YC1,YC27
YC2,YC32 (45/55 ppm model)
3. Replace the SATA cable.
4. Execute U024 to initialize (FULL) the
HDD (see page 1-3-32).
5. If an error is detected after executing
U024, replace the HDD.
Main PWB
Replace the main PWB (see page 1-5-72).
0670 Hard disk overwriting era-
sure error
HDD
1. If an abnormal noise is heard from the
HDD, replace the HDD.
2. Check the SATA wiring between the
HDD and the main circuit PWB for loose
connection, disconnection and
damages, and that it is connected into
the correct terminal.
Main PWB: YC1,YC27
YC2,YC32 (45/55 ppm model)
3. Replace the SATA cable.
4. Execute U024 to initialize (FULL) the
HDD (see page 1-3-32).
5. If an error is detected after executing
U024, replace the HDD.
Main PWB
Replace the main PWB (see page 1-5-72).
0800 Image processing error
JAM010X is detected twice.
Main PWB
Replace the main PWB (see page 1-5-72).
0830 FAX control PWB flash pro-
gram area checksum error
A checksum error occurred
with the program of the FAX
control PWB.
FAX software
1. Reinstall the fax software.
FAX control PWB
1. Execute initializing by U600.(Refer to
the FAX service manual)
2. Replace the FAX control PWB.
Code Contents Related parts
Check procedures/
corrective measures