Kyocera TASKalfa 5551ci - SD Paper Feed Motor Error (Side Deck); SM Paper Feed Motor Error (Side Multi Tray)

2L6/2N6/2N5/2N4
1-4-95
2640 SD paper feed motor error
(side deck)
[45 ppm/55 ppm model]
After SD paper feed motor is
driven, the ready signal does
not turn to L within 2 s.
SD paper feed
motor
1. To check the feed unit operation, exe-
cute U247 Side deck- Motor ON (see
page 1-3-148).
2. Check the paper feed roller and drive
gear can rotate or they are not unusually
loaded and, if necessary, replace.
3. Confirm that the wiring connector is
firmly connected and, if necessary,
connect the connector all the way in.
SD paper feed motor and SD main PWB
(YC16)
4. If the wiring is disconnected, shorted or
grounded, replace the wiring.
5. Replace the SD paper feed motor.
SD main PWB
Replace the SD main PWB (Refer to the
service manual for the paper feeder).
2650 SM paper feed motor error
(side multi tray)
[45 ppm/55 ppm model]
After SM paper feed motor is
driven, the ready signal does
not turn to L within 2 s.
SM paper feed
motor
1. To check the feed unit operation, exe-
cute U247 SMT- Motor ON (see page 1-
3-148).
2. Check the paper feed roller and drive
gear can rotate or they are not unusually
loaded and, if necessary, replace.
3. Confirm that the wiring connector is
firmly connected and, if necessary,
connect the connector all the way in.
SM paper feed motor and SM main PWB
(YC5)
4. If the wiring is disconnected, shorted or
grounded, replace the wiring.
5. Replace the SM paper feed motor.
SM main PWB
Replace the SM main PWB (Refer to the
service manual for the paper feeder).
Code Contents Related parts
Check procedures/
corrective measures