Kyocera TASKalfa 5551ci - Paper Jam: Manual Feeding (Electrical)

2L6/2N6/2N5/2N4
1-4-46
*1: 30 ppm model /35 ppm model only. *2: 45 ppm model /55 ppm model only.
(5) Paper jam during manual feeding
Electrical parts that could cause paper jam during paper travelling at the primary
feeding (to regist roller)
Timing of detection
Corrective Action
*1: 30 ppm model /35 ppm model only. *2: 45 ppm model /55 ppm model only.
3
Registration clutch (RCL)
*1
Registration motor (RM)
*2
: Operation
check (U032/30)
Feed PWB 1 YC22-2 / YC25-1 to 4
4
Feed PWB 1 : Replace
5
Engine PWB : Replace
Jam code
J0131,J0509,J0519,J4009,J4019
Related parts
Paper feed motor(PFM) Engine PWB (EPWB)
Manual feed clutch (MPPFCL) Feed PWB 1 (FPWB1)
Middle clutch (MCL)
*1
Middle motor (MM)
*2
Relay PWB (RYPWB)
* : In paper conveying unit
Registration clutch (RCL)
*1
Registration motor (RM)
*2
MP feed sensor (MPFS)
Registration sensor (RS)
Manual feed lift motor (MPLM)
MP lift sensor 1 (MPLS1)
MP lift sensor 2 (MPLS2)
Checking
procedure at the
occurrence of
J40X2
Corrective action at the occurrence of
J40X2
On/Off control signal output connector
(terminal), point of checking connection