Kyocera TASKalfa 5551ci - Page 48

2L6/2N6/2N5/2N4
1-4-47
*1: 30 ppm model /35 ppm model only. *2: 45 ppm model /55 ppm model only.
*1: 30 ppm model /35 ppm model only. *2: 45 ppm model /55 ppm model only.
Checking
procedure at the
occurrence of
J05X9
Corrective action at the occurrence of
J05X9
On/Off control signal output connector
(terminal), point of checking connection
1 Items for Initial Checks see page 1-4-29
2
MP feed sensor (MPFS): Conduct
connectivity check, mounting location
check, operation check (U031)
Feed PWB 1 YC17-9
3
Manual feed conveying clutch (CL):
Operation check (U032)
Feed PWB 2 YC4-1
4
Middle clutch (MCL)
*1
Middle motor (MM)
*2
: Operation check
(U032/30)
Feed PWB 2 YC7-14 / YC7-1 to 4
5
Feed PWB 2: Replace
6
Engine PWB : Replace
Checking
procedure at the
occurrence of
J40X9
Corrective action at the occurrence of
J40X9
On/Off control signal output connector
(terminal), point of checking connection
Items for Initial Checks see page 1-4-29
Registration sensor (RS): Conduct
connectivity check, mounting location
check, operation check (U031)
Feed PWB 2 YC7-12
Registration clutch (RCL)
*1
Registration motor (RM)
*2
: Operation
check (U032/30)
Feed PWB 1 YC22-2 / YC25-1 to 4
Feed PWB 1 : Replace
Engine PWB : Replace
Checking
procedure at the
occurrence of
J0131
Corrective action at the occurrence of
J0131
On/Off control signal output connector
(terminal), point of checking connection
1 Items for Initial Checks see page 1-4-29
2
Manual feed lift base elevation check:
1. Up-and-down movability of the paper
lift base of the manual feed tray.
2. Check if the lift lever is in contact with
the lift motor cam (re-mount the
manual feed table).
-