Kyocera TASKalfa 5551ci - Page 46

2L6/2N6/2N5/2N4
1-4-45
*1: 30 ppm model /35 ppm model only. *2: 45 ppm model /55 ppm model only
.
*2: 45 ppm model /55 ppm model only.
Checking
procedure at the
occurrence of
J13X2
Corrective action at the occurrence of
J13X2
On/Off control signal output connector
(terminal), point of checking connection
1
Items for Initial Checks see page 1-4-29
2
Middle sensor (MS) : Conduct
connectivity check, mounting location,
check operation check (U031)
Feed PWB 2 YC8-9
3
Vertical conveying clutch (PCCL):
Operation check (U032)
Feed PWB 2 YC5-3
4
Middle clutch (MCL)
*1
Middle motor (MM)
*2
: Operation check
(U032/30)
Feed PWB 2 YC7-14 / YC7-1 to 4
5 Feed PWB 2: Replace
6 Engine PWB : Replace
Checking
procedure at the
occurrence of
J15X2
Corrective action at the occurrence of
J15X2
On/Off control signal output connector
(terminal), point of checking connection
Items for Initial Checks see page 1-4-29
2
Conveying sensor (PCS) I/O check and
sensor check (U031)
Feed PWB 2 YC6-3
3
Vertical conveying clutch (PCCL):
Operation check (U032)
Feed PWB 2 YC5-3
4
Assist clutch 2 (ACSL2)
*2
:Operation
check (U032)
Feed PWB 2 YC12-1
5 Feed PWB 2: Replace
6 Engine PWB : Replace
Checking
procedure at the
occurrence of
J40X2
Corrective action at the occurrence of
J40X2
On/Off control signal output connector
(terminal), point of checking connection
1 Items for Initial Checks see page 1-4-29
2
Registration sensor (RS): Conduct
connectivity check, mounting location
check, operation check U031 and U051 -
Slack Margin Settings.
Feed PWB 2 YC7-12