5-37
Operation on the Machine > DSM Scan
3
Display the screen.
Select [WSD Scan/DSM Scan].
If WSD Scan is set to [Off] in the network settings, select [DSM Scan] and go to step 5.
4
[DSM Scan] > [Next]
5
Select the scan process to be used > [OK].
Select [Reload] to reload the computer list.
To check the settings, select [Detail].
6
Change the settings and add destinations as needed.
Only E-mail addresses can be added as destinations.
In the send base screen, select [Detail/Edit], [Destination], and then [Address Book] or
[E-mail Addr Entry], and add a destination.
In some scan processes, it may not be possible to change settings or add destinations.
7
Press the [Start] key.
Sending starts.
WSD Scan (page 8-56)
To Next Page
Loading...
