10-54
Troubleshooting > Adjustment/Maintenance
2 As shown in the illustration, place the printed side down on the platen with the edge with
the arrows toward the back.
3 Select [Start]. The pattern is read and adjustment begins.
The second pattern is output.
4 Check that the number "2" is printed at the bottom of the pattern and repeat steps 2 to 3 to
read pattern 2.
5 Select [OK] in the adjustment end confirmation screen.
Drum Refresh
Remove image blur and white dots from the printout.
1
Display the screen.
[System Menu/Counter] key > [Adjustment/Maintenance] > "Drum Refresh" [Next]
2
Perform the drum refresh.
Select [Start]. "Drum Refresh" begins.
Calibration
Calibrate the device to ensure correct toner overlapping and consistency with the original tone.
1
Display the screen.
[System Menu/Counter] key > [Adjustment/Maintenance] > "Calibration" [Next]
Drum Refresh cannot be performed while printing. Execute Drum Refresh after the printing is done.
To Next Page
Loading...
