Kyocera TASKalfa 6052ci - Offset Documents by Job

8-28
Setup and Registration (System Menu) > System Menu
Manual Staple
[System Menu/Counter] key > [Common Settings] > [Manual Staple]
Offset Documents by Job
[System Menu/Counter] key > [Common Settings] > [Offset Documents by Job]
Storing Jobs
Bates Stamp Select whether to print a bates stamp on all storing jobs.
Value: Off, On
NOTE
When [On] is selected, the Bates Stamp settings cannot be changed when storing.
Edit Bates Stamp Set the default Bates Stamp.
Value: Date, User Name, Serial Number, Numbering, Text 1, Text 2, Date Format,
Numbering Default, Position, Font
NOTE
To set [Text 1] or [Text 2], select [Change] below and enter a maximum of 32
characters for the text string.
To set [Date], select [Date Format] and set the date display format.
To set [Numbering], select [Numbering Default] and set the starting sequence
number (1 to 9999999). If you select [Fixed Digit Number] > [On], you can set the
number of digits of the serial number (1 to 7 digits).
Select [Detail] in "Position" to specify the detailed stamp position using numeric
values.
NOTE
Only displayed when the optional 4,000-Sheet Finisher is installed.
Item Description
Manual Staple Select whether to use Manual Staple.
Value: Off, On
NOTE
If you selected [On], set the time until manual stapling mode is automatically
cancelled. The setting range is 5 to 60 seconds (in 5-second increments).
Staple Position Set the default Staple Position.
Value: A4, Letter
Item Description
Offset Documents by Job Select whether to offset documents by Job.
Value: Off, On
NOTE
This function is displayed when an optional Document Finisher is installed.
Item Description