Kyocera TASKalfa 6052ci

6-26
Using Various Functions > Functions
Staple/Punch
Staple
Staples the finished documents. The staple position can be selected.
NOTE
This function requires the optional Document Finisher. Note also that saddle stitching (center stapling) requires the
Folding Unit.
For details on paper sizes and numbers of sheets that can be stapled, refer to the following:
Inner Finisher (page 11-28)
1,000-Sheet Finisher (page 11-29)
4,000-Sheet Finisher (page 11-29)
Folding Unit (page 11-31)
Item Value Description
Staple Off
Top Left Select the staple position. For details on original
orientation and staple position, refer to the following:
Original Orientation and Punch Hole Position (page
6-29)
Top Right
2 staples Left
2 staples Top
2 staples Right
Saddle Stitch Select whether to fold the finished documents in two
with staples in the center.
When placing originals, be sure to place the cover page
at the bottom. For details on saddle stitching, refer to the
following:
Booklet (page 6-49)
Original
Orientation
Top Edge on Top, Top Edge on Left,
Auto
*1
*1 This function can only be used when the optional OCR Scan Activation Kit is installed.
Select the orientation of the original document top edge
to scan correct direction. Select [Original Orientation]
to choose orientation of the originals, either [Top Edge
on Top] or [Top Edge on Left]. Then select [OK].
Copy
Org./Paper/
Finishing
Custom
Box
Functions
USB
Memory
Functions