Kyocera TASKalfa 6052ci - Page 399

8-19
Setup and Registration (System Menu) > System Menu
File Format Set the default type of the files.
Value: PDF, TIFF, JPEG, XPS, OpenXPS, High Comp. PDF
Backgrnd Density (Copy) Set the default Backgrnd Density (Copy).
Value: Off, Auto, Manual (Darker 5)
BackgrndDens. (Send/
Store)
Set the default Backgrnd Density (Send/Store).
Value: Off, Auto, Manual (Darker 5)
Prevent Bleed-thru (Copy) Set the default value for preventing bleed-through (Copy).
Value: Off, On
Prevent Bleed (Send/Store) Set the default Prevent Bleed (Send/Store).
Value: Off, On
Zoom Select the enlarged/reduced default when paper size/sending size changed after the
originals set.
Value: 100%, Auto
Border Erase Default Set the default width to be erased as a border.
Value
Metric: 0 to 50 mm (in 1 mm increments)
Inch: 0 to 2" (in 0.01" increments)
NOTE
To specify border erase widths around original, set the value in "Border". To specify
border erase widths in the middle of original, set the value in "Gutter".
Border Erase to Back Page Select the Border Erase Method for Back Page of a sheet.
Value: Same as Front Page, Do Not Erase
Margin Default Set the default margin.
Value
Metric
Left/Right: -18 to 18 mm (in 1 mm increments)
Top/Bottom: -18 to 18 mm (in 1 mm increments)
Inch
Left/Right: -0.75 to 0.75" (in 0.01" increments)
Top/Bottom: -0.75 to 0.75" (in 0.01" increments)
Auto Image Rotation (Copy) Select the default Auto Image Rotation setting.
Value: Off, On
EcoPrint Select the EcoPrint default.
Value: Off, On
Toner Save Level (EcoPrint) Select the default Toner Save Level (EcoPrint).
Value: 1 (Low) to 5 (High)
NOTE
Raising the level reduces toner consumption, but image quality falls.
High Comp. PDF Image Select the default quality setting for high compressed PDF files.
Value: Compression Ratio Priority, Standard, Quality Priority
Color TIFF Compression Select the compression method for sending the color documents in the TIFF format.
Value: TIFF V6, TTN2
Item Description