Rigging procedures
Procedure References
5. Position and attach a block of four K2 enclosures under the array. J - Attaching a block of four K2 under K2
(p.100)
Verify that the rigging arms at the back are secured by pins and
that no yellow label is visible on the front.
6. Repeat the two previous steps until the array is complete.
7. If necessary, implement a pullback with K2-RIGBAR. N - Using a K2-RIGBAR to implement a
pullback (p.120)
8. Raise the array to its nal trim height.
66 K2 owner's manual (EN) version 1.1
To Next Page
Loading...
