L-Acoustics K2 - Flying

Rigging procedures
Flying
Final check
After the setup, always verify no yellow labels are visible on the front and on both sides of the array.
At least one motor for each K2-BAR
When using two K2-BAR, do not implement a bridle between the bars.
Nobody behind the array when lifting enclosures
To avoid collisions caused by the swinging motion, do not stand behind the array when lifting the enclosures.
Safe maximum of 12 K2 enclosures in a pullback conguration
Up to 12 K2.
Space between pullback rigging points
The space between the two lifting points used for this conguration must be aligned with the array pickup points.
The deployment load-bearing lines must be parallel to each other.
Before setup, choose a ying option
Refer to SOUNDVISION modeling and to the elements for ying in Rigging system description (p.19).
To implement a pullback with a K2-BAR:
in front extension attach the shackle to hole #1.
in rear extension attach the shackle to hole #21.
K2 enclosures under K2-BUMP
K2 owner's manual (EN) version 1.1 63